Connecting The Power Supply - ELNA eXcellence 740 Manual

1
3
2
1
3
2
10

Connecting the Power Supply

First make sure the power switch is off.
Insert the machine plug of the power supply cord into the
machine socket.
Insert the power supply plug into the wall outlet, and turn
the power switch on.
1 Power switch
2 Machine plug
3 Machine socket
NOTES:
Make sure to use the power supply cord that came with
the machine.
If you turn off the power switch, wait for 5 seconds
before turning it on again.
WARNING:
While in operation, always keep your eyes on the sewing
area, and do not touch any moving parts such as the
thread take-up lever, flywheel or needle.
Always turn off the power switch and unplug the
machine from the power supply:
- when leaving the machine unattended.
- when attaching or removing parts.
- when cleaning the machine.
Do not place anything on the foot control.
If you wish to use the foot control, pull out the cord from
the foot control and insert the pin connector into the jack
on the machine.
1 Foot control cord
2 Pin connector
Insert the machine plug of the power supply cord into the
machine socket.
Insert the power supply plug into the wall outlet, and turn
the power switch on.
CAUTION:
Do not pull the foot control cord beyond the red mark.
3 Red mark
Operating Instructions:
The symbol "O" on a switch indicates the "off" position of
the switch.
For the U.S.A. only
Polarized plug (one blade wider than the other):
To reduce the risk of electric shock, this plug is intended
to fit in a polarized outlet only one way. If it does not fit
fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician to install the proper outlet.
Do not modify the plug in any way.