Connecting Machine To Power Supply - ELNA 7300 Instructions Manual

q
e
w
r
9

Connecting Machine To Power Supply

Before connecting the power cord, make sure the
voltage and frequency shown on the machine are
identical to your electrical power.
To connect machine to power supply, turn off the
power switch q. Insert the foot control plug w
and machine plug e into the machine and the
power supply plug r into the wall socket.
Your machine may come equipped with a
polarized plug (one prong wider than the other). A
polarized plug reduces the risk of electrical
shock. This plug is intended to fit into a polarized
outlet. If the plug does not fit fully into the outlet,
reverse the plug. If it still does not fit, contact a
qualified electrician to install the proper outlet. Do
not modify the plug in any way.
IMPORTANT: When using your sewing machine the
first few times, place waste fabric under the presser
foot and run the machine without thread for a few
minutes. Wipe away excess oil.
NOTE: After turning off the machine, wait 5 seconds
before turning it on again.
For Your Safety
Do not use extension cords or plug adapters.
Do not touch plug with wet hands.
Always turn off the power/light switch first and then
unplug from the electrical outlet. Examples:
• when leaving the machine unattended
• when cleaning the machine
Always turn off the power/light switch:
• when attaching or removing parts such as
needle, presser foot, needle plate
• when threading needle or bobbin
Do not place anything on the foot control.
Do not place heavy items on cords. Do not subject
cords to heat. Do not use damaged cords. Have
the cord repaired immediately.
While the machine is in operation, always keep
your eye on the sewing area and do not touch any
moving parts such as the thread take-up lever,
flywheel or needle.