Possible Malfunctions - Bartscher 195 Plus Manual

Possible Malfunctions

7 Possible Malfunctions
Mögliche
The table below contains descriptions of possible causes and solutions to
malfunctions or errors during operation of the appliance. When malfunction cannot
be removed, contact the technical service.
In such a case, provide article number, model name and serial number. These data
may be found in the rating plate.
Problem
Appliance does not
work
The blade does not cut
or the slices are fuzzy
and/or irregular
The blade sharpening
is not satisfactory
The carriage runs with
difficulties
The motor does not
work
174196
Possible cause
No power
Damaged electrical
installation
Damaged switch
Damaged motor
Blade is not sharpened
Blade excessively worn
Position is not correct
Sharpening stones are
soiled
Carriage axle not greased
enough
Sharpener is not attached
properly in the holder
Solution
Check the electric power
supply
Contact the supplier
Contact the supplier
Contact the supplier
Sharpen the blade (section
'Blade Sharpening')
Replace the blade
Fit the sharpener correctly
(section 5.2 'Operation')
Clean the sharpening
stones
Grease the carriage axles
(section 6.3
'Maintenance')
Check the sharpener
attachment
EN
27 / 28