Cleaning And Maintenance; Safety Instructions For Cleaning - Bartscher 195 Plus Manual

10. Check if the blade is sharp enough.
11. Continue until the desired sharpening level is reached.
WARNING! Cut wounds hazard!
The blade is very sharp!
Be very careful when checking the sharpness of the blade!
During operation wear class 5 cut resistant protective gloves of DIN EN 388
standard!
12. After sharpening clean the blade and sharpener elements. In order to ensure it
will operate correctly, keep the sharpener in a good condition. Observe
instructions in sections 6 'Cleaning and Maintenance'.
13. Set the sharpener back to its initial position. Follow the assembly instruction in
reverse order.
ATTENTION!
In order to keep the blade in the optimum condition and maintain safety, it
should be replaced when its height is reduced by approx. 5–7 mm.
6

Cleaning and Maintenance

EN
6.1

Safety Instructions for Cleaning

•
Before cleaning, disconnect the appliance from the power supply.
•
Leave the appliance to cool down completely.
•
Make sure water does not enter the appliance. Do not immerse the appliance in
water or other liquids during cleaning. Do not clean the appliance with a
pressurized water jet.
•
Do not use any sharp or pointed, nor metal implements (knife, fork, etc.). Sharp
or pointed implements may damage the appliance, and when in contact with live
parts, they may cause electric shock.
•
For cleaning, do not use any scouring agents that contain solvents nor corrosive
cleaning agents. They may damage the surface.
22 / 28
Cleaning and Maintenance
174196