Table of Contents
Advertisement
10. Move the carriage (6) slowly and steadily towards the blade (1) using the pusher
handle (4).
11. The best slicing results are obtained when the pusher handle (4) is slightly
pushed towards the movable slice thickness partition (13).
The product to be sliced encounters the blade (1), the sliced product is separated
and falls onto the tray (12), which is located on the back of the movable slice
thickness adjustment partition (13).
Do not remove the pusher handle with the pusher (4) unless the food product to be
sliced is of unusual size or shape.
12. After cutting, the carriage (6) is to be put into initial position and the slice
thickness adjustment knob (8) should be set to '0' position.
13. Switch the appliance off with the black STOP button (A) in the appliance
ON/OFF switch (9). Do not allow the appliance to run idle.
14. The sliced good can be now removed from the slice tray.
WARNING!
Cut wounds hazard!
Never operate the appliance with wet or moist hands.
Never put hands between the blade (1) and the pusher handle (4) or the
EN
movable slice thickness partition (13) until they are fully closed (slice thickness
adjustment knob (7) set to '0' position).
During operation keep hands away from the blade in order to avoid cuts and
accidents. Use the handle of the pusher (4).
WARNING!
Never use the appliance for more than 15 minutes in order to avoid motor
overheating. After a short break the appliance may be switched on again.
20 / 28
Installation and operation
174196
Advertisement
Table of Contents
