Solid State Logic UF8 User Manual page 82

Plug-in Mixer Tutorial
V-Pots and Fader
Selection Mode
The primary purpose of the NORM and REC keys in the SELECTION MODE section is to determine the behaviour of the SEL keys.
NORM - The SEL keys function as select keys in the Plug-in Mixer
REC - N/A
AUTO - N/A
The secondary labels CLEAR and ZERO refer to the push and hold functions available.
CLEAR SOLOS/MUTES - Press and hold the CLEAR key and press any active SOLO key
to clear all Channel Strip Solos. Press and hold the CLEAR key and press any active CUT
to clear any Channel Strip Cuts.
DEFAULT PARAMETER ASSIGNED TO THE FADER - Press and hold the ZERO key and press any SEL key to default the
parameter that is being controlled across the faders on that track.
82
V-Pot
At the top of each strip is the V-Pot (virtual pot). The function of the V-Pot varies, depending
on which V-Pot assignment mode is currently active.
The V-Pot has a push function, which is used for defaulting the position of the parameter being
controlled.
100 mm Motorised Fader
By default the faders are assigned to the OUTPUT TRIM Gain in Channel Strip Mode or the
MAKE-UP Gain in Bus Compressor mode. However, any parameter that is assigned to the
V-Pots with continuous control (i.e. not switch functions) can be flipped onto the fader with
the FLIP key.
Solo, Cut & Sel (Select)
Each strip contains SOLO, CUT and SEL keys.
In Channel Strip Mode, the SOLO and CUT keys control Solo and Cut buttons in the Channel
Strip plug-in, whilst SEL key selects the Channel Strip in the Plug-in Mixer.
In Bus Compressor Mode, the SEL key selects the Bus Compressor in the Plug-in Mixer.
SSL UF8 User Guide