Table of Contents
Advertisement
2
Initial Setup
To set up the Horizontal time base
1 Press the [Menu/Zoom] key (or [Main/Delayed] key on some oscilloscopes) in the
Normal
sweep mode
XY or Roll
mode
The Horizontal Menu lets you select the horizontal mode (Normal, Zoom, XY, or
Roll), and set the time base fine adjustment and time reference.
The current sample rate is displayed above the Fine and Time Ref softkeys.
Normal mode
1 Press the Normal softkey to select Normal horizontal mode.
2 Turn the large knob (time/division) in the Horizontal section and notice the
50
Horizontal section of the front panel.
Trigger point Time
Zoom sweep
mode
Normal horizontal mode is the normal viewing mode for the oscilloscope. When
the oscilloscope is stopped, you can use the Horizontal knobs to pan and zoom
the waveform.
change it makes to the status line.
Delay
reference
time
Sample rate
Horiz. pos
knob mode
Keysight InfiniiVision 6000L Series Oscilloscopes User's Guide
Sweep
Trigger
Trigger level or
source
threshold
speed
Time base
fine
adjustment
Time
reference
Advertisement
Table of Contents
