Fieldmann FDUO 50501 Instruction Manual page 15

Straight cutting
Ensure the work piece is firmly secured in a vice or workbench.
Mark a line on the work piece through which the cut is required.
Start up the jig saw and place the front of the base plate onto the work piece.
Align the blade with the cutting mark on the work piece.
Slowly move the jig saw forward along the cutting mark. Press the jig saw down firmly onto
the work piece to prevent the blade from snagging or breaking.
Allow the tool to work at its own pace, letting the blade cut freely - do not force the tool.
Increasing pressure will not result in a faster cut.
Choose an appropriate blade according to the required job and finish, depending on the
type and thickness of the material. Large teeth will give a quick, coarse cut and small teeth
will produce a quality finish.
When cutting thin board, place it on a wood board to help absorb vibrations
ON/OFF switch
The on/off switch (1) is located in the saw handle.
Depress the trigger switch to turn on the jig saw.
The on/off switch can be locked with the locking button on the side of the saw handle.
To unlock the switch, depress the switch button again. Always ensure that the switch is in the
off position before connecting the tool to the mains. Always disconnect the tool from the
mains when not in use.
Speed control
The speed of the machine can be adjusted by operating the speed control wheel on the front
of handle.
To increase the speed, turn the wheel forward, and to decrease the speed, turn the wheel
backwards.
Cleaning and Storing Instructions
WARNING! Prior to maintenance and cleaning, ensure the power is disconnected from
the saw. Unplug the power cable from the power supply network. Use only mild soap and a
slightly damp cloth to clean your saw. Many household cleaners contain chemicals which
could seriously damage the plastic. Do not use petrol, turpentine, lacquer or paint thinners
or similar products to clean the machine. Never let any liquid get inside the tool and never
immerse any part of your saw into liquid.
Never use water or other liquids to clean the electrical parts of the tool.
Always clean the tool after use.
Ensure the ventilation slots do not become blocked to prevent overheating.
CORDLESS RECIPROCATING SAW
Operation 15
OPERATING INSTRUCTIONS
EN