SpectraLink NetLink e340 Install Manual page 8

SpectraLink Corporation
NetLink Telephony Gateways
Menu options can be changed in the Administration Console of the NetLink
Telephony Gateways. The Delay function is used when the PBX uses softkeys. With
Delay, when the FCN key is pressed, the handset displays the features that are
associated with the softkeys so that one of these features can be selected first. If
Delay is programmed, pressing the FCN key twice will bring up the menus
immediately. Under the menu programming section of the Administration console
there is an option to use Delay (same as the Link 3000 MCU).See NetLink Telephony
Gateway: Installation, Configuration, and Administration for the NetLink for further
details. Also refer to the same document for details on configuring the telephone
switch type
Hold
The Hold feature should be programmed to the Hold key as shown on the Key-map
Diagrams so that when the
on hold.
Mute
The handset Mute function is hard-coded in the Link WTS to FCN+1. This function
sequence is recommended, but the system administrator can assign the Mute
function to any available function key sequence or leave the function unassigned.
Voicemail
The message-waiting icon (
indication of the deskset. The voicemail feature on the deskset must be assigned to
the feature key as shown in the Key-map Diagrams. Do not assign any other feature
to this key, since the associated LED is directly mapped to the message-waiting icon
on the handset. This LED assignment must be used in order to support the message-
waiting icon. Using this key for any other feature or for line access could cause
unacceptable system performance.
Speakerphone
Because the handset has no speaker, the Microphone, Speaker, and Volume
Up/Down buttons on the 420 have no corresponding handset function.
Ring Types
Handset ring types (soft, normal, vibrate, etc.) are programmed by the handset user
and are not accessible or changeable by the system switch. Whenever possible the
audible ringer on the handset will follow the cadence provided by the system switch.
Call progress tones provided by the host system will be passed through to the
handset.
Part Number: 72-0171-10-C.doc
button is pressed on the handset, the call is placed
Hold
) on the handset is activated with the message
MSG
LinkPlus Interface Guide
Mitel SX-50, -200, -2000 System
Page 8