SpectraLink PTE140 Technical Bulletin

High Noise Mode functionality on e340 or i640 Wireless Telephones
Date:
Software Versions:
Hardware Revisions:
Product Type:
Access Level:
Problem
When changing the High Noise Mode setting in the Wireless Telephone, the change
does not take place until the phone is turned off and back on again. On some protocols,
changing the High Noise Mode has no effect on that setting.
Description
The following list of software versions (based on protocol) is where the problem will
occur. If you have this version, or an earlier one, then you will have to re-boot the
Wireless Telephone after you have changed the High Noise Mode setting.
SRP –
Cisco SCCP -
Avaya CCMS -
Nortel UNIStim -
H.323 -
Inter-Tel Axxess -
Mitel ICP -
Resolution
The following list of future releases will correctly fix the problem. The user will no longer
have to re-boot the Wireless Telephone to get the change to take effect. Release dates
are unknown at this time. Please check
SRP –
Cisco SCCP -
Avaya CCMS -
Nortel UNIStim -
H.323 -
Inter-Tel Axxess -
Mitel ICP -
THE INFORMATION PROVIDED IN THE SPECTRALINK TECHNICAL BULLETIN IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. NO
OBLIGATION OR LIABILITY WILL ARISE OUT OF, SPECTRALINK RENDERING TECHNICAL OR OTHER ADVICE OR SERVICE IN CONNECTION
SpectraLink Corporation • 5755 Central Avenue • Boulder, Colorado 80301 • 303.440.5330
June 03, 2004
See Below
PTE1xx, PTX1xx
NetLink Wireless Telephones
General
89.104
91.035
96.024
97.030 (No change occurs)
99.012
100.011 (No change occurs)
101.004 (No change occurs)
www.spectralink.com
89.110
91.039
96.025
97.039
99.013
100.012
101.007
HEREWITH.
Technical Bulletin CS-04-04
Originator:
Approvers:
Status:
Revision:
for software updates.
Matt Jerger
Wayne McAllister
Gary Bliss
Approved
A