Spectra Logic T-Series Spectra T50e Hardware Replacement Manual page 14

Replacing the Library Control Module
Installing the LCM
1. Remove the new LCM from the packaging.
Note:
Keep the packaging to return the old LCM to Spectra Logic.
2. Slide the new LCM into the empty slot.
a. Align the two edges of the LCM card with the guide slots in the chassis.
Back of Library
Align LCM in
guide slots
Figure 4 Align the LCM in the guide slots in the chassis.
b. Push the LCM it in until it is flush against the chassis. The pressure needed is
about the same as when installing RAM in a computer. If the card does not
"snap" into place, verify that the LCM card edges are aligned in the guide slots.
3. Tighten the two screws using a #2 Phillips screwdriver or your fingers, shown in
Figure 3, to secure the LCM to the chassis.
Note:
The new LCM ships from the factory with a new flash card. If the
card is not installed or is loose, gently push the card into the open
slot until it snaps (clicks) into place.
The card inserts easily when it is oriented correctly. Do not force it.
Caution:
unless directed to do so by SpectraGuard Technical Support.
Installing a corrupted flash card can cause the new LCM to fail.
4. Power on the library via the front panel (see Figure 2).
14
Do not install the flash card from the LCM you replaced