Image Parameters Switch; Video Standard; Local Video Output - HIKVISION DS-2CD6D44G1H-IZS User Manual

Note
This function is only supported by certain device equipped with motorized lens.
●
The edge of image will be lost if this function is enabled.
●

4.5.2 Image Parameters Switch

The device automatically switches image parameters in set time periods.
Go to image parameters switch setting page: Configuration → Image → Display Settings → Image
Parameters Switch , and set parameters as needed.
Set Scheduled-switch
Switch the image to the linked scene mode automatically in certain time periods.
Steps
1. Check Scheduled-switch.
2. Select and configure the corresponding time period and linked scene mode.
Note
For Linked Scene configuration, refer to Scene Mode .
3. Click Save.

4.5.3 Video Standard

Video standard is an ability of a video card or video display device that defines the amount of
colors that are shown and the resolution. The two most common video standard used are NTSC
and PAL. In NTSC, 30 frames are transmitted each second. Each frame is made up of 525 individual
scan lines. In PAL, 25 frames are transmitted each second. Each frame is made up of 625 individual
scan lines. Select video signal standard according to the video system in your country/region.

4.5.4 Local Video Output

If the device is equipped with video output interfaces, such as BNC, CVBS, HDMI, and SDI, you can
preview the live image directly by connecting the device to a monitor screen.
Select the output mode as ON/OFF to control the output.
Network Camera User Manual
24