Table of Contents
Advertisement
Improper replacement of the battery with an incorrect type may defeat a safeguard (for
●
example, in the case of some lithium battery types).
Do not dispose of the battery into fire or a hot oven, or mechanically crush or cut the battery,
●
which may result in an explosion.
Do not leave the battery in an extremely high temperature surrounding environment, which may
●
result in an explosion or the leakage of flammable liquid or gas.
Do not subject the battery to extremely low air pressure, which may result in an explosion or the
●
leakage of flammable liquid or gas.
+ identifies the positive terminal(s) of equipment which is used with, or generates direct current.
●
- identifies the negative terminal(s) of equipment which is used with, or generates direct current.
Fire Prevention
No naked flame sources, such as lighted candles, should be placed on the equipment.
●
The serial port of the equipment is used for debugging only.
●
Hot Surface Prevention
●
CAUTION: Hot parts! Burned fingers when handling the parts. Wait one-half hour
after switching off before handling parts. This sticker is to indicate that the marked item can be
hot and should not be touched without taking care. For device with this sticker, this device is
intended for installation in a restricted access location, access can only be gained by service
persons or by users who have been instructed about the reasons for the restrictions applied to
the location and about any precautions that shall be taken.
Installation
Install the equipment according to the instructions in this manual.
●
To prevent injury, this equipment must be securely attached to the floor/wall in accordance with
●
the installation instructions.
Never place the equipment in an unstable location. The equipment may fall, causing serious
●
personal injury or death.
Power Supply
The input voltage should conform to IEC60950-1 standard: SELV (Safety Extra Low Voltage) and
●
the Limited Power Source. Refer to the appropriate documentation for detailed information.
The power source should meet limited power source or PS2 requirements according to IEC
●
60950-1 or IEC 62368-1 standard.
DO NOT connect multiple devices to one power adapter, to avoid over-heating or fire hazards
●
caused by overload.
Make sure the plug is properly connected to the power socket.
●
Network Camera User Manual
vii
Advertisement
Table of Contents
