Preparing Appliance For Installation - Vision Ezi-Slide V150 B Installation & User's Instructions

Control gas fire

Table of Contents

INSTALLER GUIDE

8. PREPARING APPLIANCE FOR INSTALLATION

1. Detach the burner unit from the convection box by removing two screws (See

figure 10). Lift the burner unit clear.

2. Fit the two "U" section seals to the bottom edges of the convection box side

flanges (See figure 11).

3. It is important that the grommet

supplied in the loose parts pack is

fitted to the hole in the rear of the

convection box.

4. For concealed connection only:

Pierce the grommet to allow the pipe to

pass through it. The grommet should

envelop the pipe. If the hole is larger

than the pipe, seal it with tape. Do not

pierce the grommet unless the supply

Figure 10. Burner attachment points

pipe is to pass through it.

6. The heat engine or fascia will have a canopy shield

supplied with it. Fit this to the convected air outlet of the

appliance using the three self tapping screws supplied.

The design of the canopy shield may differ from that

shown (See figure 12).

Figure 11. 'U' Seals

Figure 12. Fitting canopy shield

Table of Contents

Table of Contents