Sealing Floor Front - All Installations - Vision Ezi-Slide V150 B Installation & User's Instructions

INSTALLER GUIDE
INSTALLER GUIDE
10. Fit a cable retainer over the bottom end of
Side entry
Rear entry
each cable.
11. Pull each cable taut. Push the cable
retainers hard up against the back panel. The
end of the cable adjuster will pass into the
hole. Tighten the screws in the retainers so
that they clamp the cables in position. Apply
tension to the cables by turning the hexagonal
adjusters by hand (See figure 21).
12. Inspect the installation of the convection
box against the fireplace surround. If the
convection box is aligned squarely and the
sealing is satisfactory, fully tighten the cable
retainers.
13. If the convection box is not correctly
aligned, release the tension on the cables by
slackening the screws and turning the
hexagonal adjusters fully anticlockwise. The
convection box should then automatically
realign itself. Pull each cable taut again and
push the cable retainers back against the back
panel. Again, tighten the screws in the
retainers and apply tension to the cables by
turning the hexagonal adjusters clockwise as
Figure 21. Lower cable retention
far as possible.
14. Feed the free length of the cables into the
gap between the inner and outer back panels
so that they are available to allow easy
removal and refitting of the appliance during
subsequent service calls. Do not cut off the
free lengths of cable. On precast flue
installations feed the cables into the small
holes at the base of the side panels (See
figure 21).

9.3 Sealing floor front - all installations.

Using the floor sealing tape supplied, seal the
bottom of the convection box to the fireplace
Figure 22. Floor sealing
and hearth floor (See figure 22).
Make sure that the whole length of the front edge of the convection box is fully
sealed.
24