Installation - Vision E-line solus VS220 Instruction Manual

Table of Contents

Before installation, check that all parts are included and undamaged. If the appliance is damaged, check with the

supplier before installation and operation. If the mains power supply lead is damaged in any way, it must be replaced

by a suitable equivalent approved by the manufacturer.

The main box contains the appliance, 2 x suction cups and 1 x magnet tool. Packed with the appliance (behind the

glass panel) are additional boxes each with a contents list printed on the outside of each box.

PREPARING THE APPLIANCE

GLASS REMOVAL – ACCESSING PARTS

To gain access to various contents required for installation follow steps shown in Fig.1 through to Fig.4 to remove the

glass panel on the front of the appliance.

FIG. 1

FIG. 3

REMOVAL OF WALL MOUNTING BRACKET

The wall mounting bracket is secured to the rear panel of the appliance. Remove the screws and the wall mounting

bracket and put aside for later use – see Fig. 5.

POWER CABLE

After inserting the power cable into the socket on the bottom right side of the appliance, secure in place using the

power cable securing bracket and ST4*8 screw (found inside Box #1) – see Fig.6.

FIG. 2

FIG. 4

INSTALLATION

Table of Contents