Table of Contents
Advertisement
OWNER GUIDE
4. For a higher heat level slide the button upwards. The burner flames and heat
output will gradually increase until the button reaches the high heat position shown in
figure 2. When the button reaches the high heat position you will feel a check to its
movement. Do not slide the button above the high heat position unless you
want to turn the fire off (See note i below).
Note i) If the flames go out while setting the control, repeat the full lighting
procedure. If the flames repeatedly go out have the fire serviced.
ii) Please note. When first turned on the flames will appear predominantly blue.
The ceramic fuel effect pieces will take time to warm up. Although some
glow will be seen after approximately ten minutes, the full visual effect will
only be apparent after a somewhat longer time.
iii) The appliance will operate to its maximum potential if the flue is primed
during the first 20 – 30 minutes of operation. To do this, simply slide the
control button to its highest setting. This will also burn off any carbon
deposits that may have formed during previous operations.
iv) If operating the appliance for long periods it is beneficial occasionally to
change the settings. This will also help to remove any carbon deposits that
may form during operation.
To turn the fire off.
1. Slide the button up past the high heat position to the "O" position. Both the main
burner and the pilot should go out. While cooling,
the ceramic fuel effect pieces may make some
crackling noises. This is quite normal.
Lighting with a taper.
(See figure 3).
In the unlikely event of failure of the ignition spark,
the pilot can be lit by a taper or long spill. Insert
the taper or spill between the second and third left
hand ceramic fuel effect pieces on the first row.
Operate the slide control as described above.
OWNER GUIDE
Figure 3. Lighting with a taper
(The fuel effect may differ from
that shown)
43
Advertisement
Chapters
Table of Contents
