Fitting The Ceramic Fuel Effect & Slider Button - Vision Ezi-Slide V150 B Installation & User's Instructions

INSTALLER GUIDE
INSTALLER GUIDE
the ledges at the sides of the
firebox. Slide them in from the
front and ensure that the touch
the rear wall. The friction
between the side walls and the
rear wall should hold the side
walls in position (See figure
26).
5. Re-fit the spillage plate. Be
careful not to damage the
edges of the side walls. The
spillage plate will hold the side
walls in place.
Figure 26. Ceramic side walls installation
12. FITTING THE SLIDER BUTTON & CERAMIC FUEL EFFECT 12. FITTING THE CERAM IC FUEL EFFECT
12.1 Fitting the slider button.
Fit the slider button to the top of the
slider using the screw(s) supplied (See
figure 26a). Note that some models
may feature just one screw.
12.2 Fitting the ceramic fuel effect.
The fitting guide for the ceramic fuel
effect is supplied with the ceramic fuel
effect. It is important that the fitting
guide for the ceramic fuel effect be
placed inside or attached to this guide
Figure 26a. Fitting the slider button
and handed to the customer following
completion of the 'final review' section.
Ensure that the fire is OFF. Open the isolating valve at the inlet 'T' connector and
replace the end cap. Light the fire, turn to the maximum output position and test
around the sealing screw for gas soundness with a suitable leak detection fluid.
27