Southbend 3230 Owner's Manual page 7

INSTALLATION
t
B. 3230AW Mounted to Wall
1. Each 3230AW will be mounted to the wall with one of the following kits:
EACH BLACK KIT INCLUDES: (Kit No. 4440035)
r
WY.
1
1
1
B
6
11
11
11
8
1
2
1
1
Part No. Description
Item No.
1073106
Right Mounting Bracket
(1)
1073105 Left Mounting Bracket
(1)
1073104
Wall Plate
(2)
1073107
Fig. 2
False Back
(3)
1073100 Bottom Support
(4)
Self Tapping Screws - x-20
1146341 Machine Screws - lo-24
1146410 Square Nuts - lo-24
1146501
Lock Washer - "/,,
1146300
Sheet Metal Screws - #lO x %
1163558 Bottom Cover
1163560
Bottom Bracket
iii Fig. 3
1173329
Air Wash Baffle
(6)
1173337 Air Wash Stiffener
(7)
J
EACH STAINLESS STEEL KIT INCLUDES: (Kit No. 4440036)
WY.
Part No. Description Item No,
1 1073103
Wall Plate
(2)
1
1073108
False Back (3) Fig. 2
1
1073102 Right Bottom Support
(4)
1 1073101
Left Bottom Support
(4)
SAME MOUNTING BRACKETS AS ABOVE
SAME SCREWS AS ABOVE
1 1166917 Flue Diverter
(5)
1
1173329 Air Wash Baffle
(6)
1 1173337 Air Wash Stiffener
(7)
FASTENER CODE
S-l
x-20 Self-Tapping Screw
S #lO Sheet Metal Screw
N-B lo-24 Nut, Lock Washer, Machine Screw
(Drill 306" hole for N-B - S/32" hole for S - 7132" hole for S-l)
2. Attach right and left mounting brackets (1) to unit with three x-20 self-tapping screws (S-1)
each (see Fig. 2). The six holes for the mounting brackets must be drilled in the unit. Use
a 7132" dia. drill bit.
3. Attach wall plate (2) to false back (3) with five lo-24 machine screws, lockwashers and nuts
(N-B). Attach wall plate (2) so that top row of holes is above top of false back (3). The five
holes in the false back (3) which the wall plate (2) attach to must be drilled. Use a 3/16" dia.
drill bit.
4. Attach false back (3) to right and left mounting brackets (1) with six #lO sheet metal screws
(S). The holes must be drilled in the mounting brackets. Use a 5/32" dia. drill bit.
5. Lay unit carefully on the false back. Take off bottom of unit by removing the six sheet metal
screws which secure it. Set the bottom aside; it will not be used again.
6. Attach two bottom supports (4), and false back (3), to unit with three lo-24 screws, lock-
washers and nut (N-B) each. The six holes must be drilled in the bottom of the unit (4 holes)
and false back (2 holes). Use a 3/16" dia. drill bit.
7. Attach entire unit and assembly to wall with appropriate screws (furnished by installer).
Use the five holes at top of wall plate (2) and the three holes each on the bottom supports (4).
SALAMANDER RADIANT BROILER
SECTION ONE - INSTALLATION
PAGE 5