Southbend 3230 Owner's Manual page 5

INSTALLATION
t
PLEASE NOTE C LEARANCES BELOW:
Minimum clearances from COMBUSTIBLE CONSTRUCTION are:
TYPE
SIDES
I
ALL MODELS
T
6 IN. 6 IN.
I
I
WALL MOUNTED UNITS
I
6 IN.
I
OIN.
I
The Minimum clearances from NON-COMBUSTIBLE CONSTRUCTION are:
TYPE
SIDES
I
ALL MODELS
I
OIN.
I
0 IN.
I
I
WALL MOUNTED UNITS
I
OIN.
I
OIN.
I
NOTE: No additional clearance from the sides and rear is required for service, as the units are
serviceable from the front.
WARNINGZ
THESE PROCEDURES MUST BE FOLLOWED BY QUALIFIED PERSONNEL OR
WARRANTY WILL BE VOIDED.
WARNING:
FOR AN APPLIANCE EQUIPPED WITH CASTERS, THE INSTALLATION SHALL BE
MADE WITH A CONNECTOR THAT COMPLIES WITH THE STANDARD FOR
CONNECTORS FOR MOVABLE GAS APPLIANCES, ANSI 221.69~LATEST EDITION,
CAN1 6.1068, AND A QUICK-DISCONNECT DEVICE THAT COMPLIES WITH THE
STANDARD FOR QUICK-DISCONNECT DEVICES FOR USE WITH GAS FUEL, ANSI
Z21.41-LATEST EDITION AND CAN1 6.9 M79. ADEQUATE MEANS MUST BE
PROVIDED TO LIMIT THE MOVEMENT OF THE APPLIANCE WITHOUT
DEPENDING ON THE CONNECTOR AND THE QUICK-DISCONNECT DEVICE OR ITS
ASSOCIATED PIPING TO LIMIT THE APPLIANCE MOVEMENT.
WARNINGZ
IF DISCONNECTION OF THIS RESTRAINT IS NECESSARY TO MOVE THE
APPLIANCE FOR CLEANIN G, ETC., RECONNECT IT WHEN THE APPLIANCE IS
MOVED TO ITS ORIGINALLY INSTALLED POSITION.
NOTE: Adequate restraining means must be attached to rear of appliance when installed. Installation
must conform to local codes as applicable.
ASSEMBLY INSTRUCTIONS FOR MODEL 3230A SAl&HANDER:
The Model 32308 can be mounted to a Sectional Series Range or be mounted to a wall t323OAW).
A. 3230A Mounted to a Sectional Range.
The 3230A is completely assembled at the factory to the flue riser of the specified sectional range as
ordered. The flue riser may or may not be mounted to the sectional range. If it is not proceed as
follows:
1. Front panel "A" is fastened with six (6) sheet metal screws. Remove the screws and the panel
will come loose. (See Fig. 1.)
2. Remove the nuts and lockwashers from collar plate studs "C" on unit.
3. Lower the flue riser with the 3230A mounted on it onto the unit such that studs "C" enter
the holes in the shelf bracket. Be certain to adequately support the broiler. Secure shelf
bracket "B" with the nuts and lockwashers which were removed previously.
4. The flue riser extension "D" is packed with the unit. Slide extension over the flue "E"
protruding through the center opening of the collar plate "F."
SAMblANDER RADIANT BROILER
SECTION ONE - INSTALLATION
PAGE 3