Southbend 3230 Owner's Manual page 6

\
INSTALLATION
5. Replace panel "A,"
6. Locate rear stiffeners (2 per unit), Part No. 1162339 for 42" deep units, and Part No.
1162340 for 36" deep units. The stiffeners have 10 pre-punched holes each.
7. Hold stiffeners against the rear of the unit with their outside edge approximately 718" from
the right and the left edges of the unit. Mark the stiffener hole locations on back of unit.
8. Drill out the holes at the rear of the unit with a 7/32" dia. drill bit.
9. Mount each stiffener with ten (10) l/4-20 self tapping sheet metal screws (Part No.
1146313).
10. Supporting mechanism can now be removed from broiler.
MOUNTING SHELF OR BACKSPLASH
INSTALLATION INSTRUCTIONS
FIGURE 1
SALAMANDER RADIANT BROILER
SECTION ONE - INSTALLATION
PAGE
4
Lifho m U.S.A.
2-94