Before Initial Operation; Requirements; Install Software; Install Driver - Cleco CellTek CTBA Quick Installation Manual

3

Before Initial Operation

3.1

Requirements

To set up the controller, the following items are required:
Laptop/PC
•
Ethernet cable
•
Software S168691 mProRemote Professional
•
• Software S168688 LiveWire Utilities
Monitor with VGA connector, keyboard and mouse (optional)
•
Micro-B USB cable
•
3.2

Install Software

1. Download the mProRemote Professional and LiveWire Utilities Software from the follow-
ing website: http://software.apextoolgroup.com/current-software-packages/pc-software/
2. Install the mProRemote Professional software on the PC, see Document S168691 mProRe-
mote Professional.
3. Install the S168688 LiveWire Utilities on the PC, see Document P2372JH.
4. Install the tool driver.
5. Set network settings from laptop/PC to i. e. 192.168.100.201 (if mPro200GC-AP is used).
3.3

Install driver

To be able to configure the tool via the PC software, the tool driver must be installed.
Install tool driver
1. Download the tool driver cellcore-celltek-usb-driver.zip from the following website and un-
pack it: https://software.apextoolgroup.com/current-software-packages/celltek/
2. Connect the tool to the PC via a Micro-B USB cable.
The tool switches on automatically.

3. Open the device manager on the laptop/PC.
Apex Tool Group P2545KA | 2022-12 | REV C
Before Initial Operation
3
EN
9