Lockly SECURE PLUS User Manual page 19

3.6 Adding a Fingerprint (Continued)
Upon pressing "FP", you will enter Fingerprint Registration Mode and you will see a green LED ring
light up on the fingerprint panel on the exterior side of Lockly Secure Plus / Pro.
SECTION 3.6
Once you're in Fingerprint Registration Mode you will see two numbers
displayed on keypad. The top number is your Fingerprint Registration
number, in this example to the left, "1". The bottom number will always
start with a "6".
You must successfully scan your fingerprint six (6) times for it to properly
register. Every time you scan your fingerprint, the number on the bottom
will change, starting from 6 - then 5, 4, 3, 2, 1, until the fingerprint is
successfully registered.
Note: For reference, please keep a record of your fingerprint registration
number to distinguish whom it was registered to.
*Only works when lock is not paired with a smart phone device.
While in Programming Mode*, select
"1AD" to add an Access Code. If you
are not in Programming Mode, please
see Section 3.2 to enter Program-
ming Mode.
After pressing "1AD" press "FP" to
register a Fingerprint.
17