pickering
USING PICKERING DRIVERS IN LabVIEW
Most Pickering drivers include a LabVIEW wrapper to permit full operation of the Pickering product from the
LabVIEW environment. These wrappers are normally installed to the current LabVIEW folder system during
installation of the Pickering driver.
The process of controlling a Pickering product normally consists of the following steps:
1.
Open a control session on the product
2.
Use functions in the library to operate the product
3.
Close the control session
The following is a simple example of the use of the most common Pickering drivers:
Figure 5.3 - Example of Using a Pickering Module With LabVIEW
To download LabVIEW examples. Please go to:
http://wiki.pickeringtest.net/Using+Pickering+Drivers+in+LabView
1-POLE 2A BRIC 3U PXI MULTI-SLOT MATRIX 40-597
SECTION 4 - PROGRAMMING GUIDE
Page 4.5