Table of Contents
Advertisement
Confidential
ESC 3 n
[Name]
Set line spacing
[Format]
ASCII
Hex
Decimal
0 £ n £ 255
[Range]
[Description] Sets the line spacing to [ n ´ vertical or horizontal motion unit] inches.
· The line spacing can be set independently in standard mode and in page mode.
[Notes]
· The horizontal and vertical motion unit are specified by GS P. Changing the
horizontal or vertical motion unit does not affect the current line spacing.
· The GS P command can change the horizontal (and vertical) motion unit.
However, the value cannot be less than the minimum vertical movement
amount, and it must be in even units of the minimum vertical movement
amount.
· In standard mode, the vertical motion unit (y) is used.
· In page mode, this command functions as follows, depending on the starting
position of the printable area:
When the starting position is set to the upper left or lower right of the
printable area using ESC T, the vertical motion unit (y) is used.
When the starting position is set to the upper right or lower left of the print
able area using ESC T, the horizontal motion unit ( x ) is used.
· The maximum paper feed amount is 1016 mm (40 inches). Even if a paper
feed amount of more than 1016 mm (40 inches) is set, the printer feeds the
paper only 1016 mm (40 inches).
[Default]
Line spacing equivalent to approximately 4.23mm (1/6 inches).
[Reference]
ESC 2, GS P
TITLE
ESC
3
1B
33
27
51
TM-T88 II II II II series
Specification
(STANDARD)
n
n
n
NO.
SHEET
REVISION
NEXT
D
SHEET
85
86
Advertisement
Table of Contents
