Gs ¥ Nl Nh - Epson TM-T88IIP Manual

Confidential
GS \ n n
L H
[Name] Set relative vertical print position in page mode
[Format] ASCII
Hex
Decimal
0 £ n £ 255
[Range]
L
0 £ n £ 255
H
[Description] Sets the relative vertical print starting position from the current position in page
mode.
· This command sets the distance from the current position to [( n
´ vertical or horizontal motion unit] inches.
· This command is ignored unless page mode is selected.
[Notes]
· When pitch N is specified to the movement downward:
n + n
L
When pitch N is specified to the movement upward (the negative direction), use
the complement of 65536.
When pitch N is specified to the movement upward:
n + n
L
· Any setting that exceeds the specified printing area is ignored.
· This command function as follows, depending on the print starting position set
by ESC T:
When the starting position is set to the upper left or lower right of the
printing, the vertical motion unit (y) is used.
When the starting position is set to the upper right or lower left of the printing
area, the horizontal motion unit (x) is used.
· The horizontal and vertical motion unit are specified by GS P.
· The GS P command can change the horizontal (and vertical) motion unit.
However, the value cannot be less than the minimum horizontal movement
amount, and it must be in even units of the minimum horizontal movement
amount.
[Reference] ESC $, ESC T, ESC W, ESC \, GS $, GS P, 3.12 Page Mode
TITLE
GS \
1D 5C
29 92
´ 256 = N
H
´ 256 = 65536 - N
H
TM-T88 II II II II series
Specification
(STANDARD)
n n
L H
n n
L H
n n
L H
NO.
SHEET
REVISION
NEXT
D
´ 256)
+ n
L H
SHEET
127
128