Table of Contents
Advertisement
Confidential
2) DIP switch 2: 8 switches
SW 2
Function
1
Handshaking (BUSY condition)
2
Reserved (Do not change settings)
3
Selects print density /
4
Low power consumption mode
5
Reserved (Do not change settings)
6
Reserved (Do not change settings)
7
I/F pin 6 reset signal (*1)
8
IF pin 25 reset signal (*2)
(*1)(*2) With the RS-485 serial interface specification (a dealer option), DIP Switches 2-7 and
2-8 are disabled.
Level
-
1
2
3
NOTES: · Changes in DIP switch settings (excluding switches 2-7 and 2-8 interface reset
signals) are recognized only when the printer power is turned on or when the
printer is reset by using the interface. If the DIP switch setting is changed after the
printer power is turned on, the change does not take effect until the printer is turned
on again or is reset.
· If you turn on DIP switch 2-7 or 2-8 while the printer power is turned on, the printer
may be reset, depending on the signal state. DIP switches should not be changed
while the printer power is on.
· If the print density is set to level 2 or 3, printing speed is inclined to be low speed.
· In low power consumption, printing speed is fixed to 70 mm/sec.
TITLE
Table 3.3.3 DIP Switch 2
ON
ùReceive buffer full ùOff line
---
Refer to Table 3.3.4
---
---
Enabled
Enabled
Table 3.3.4 DIP Switch 2-3 and 2-4
Function
Low power consumption mode
Print density (Normal)
Print density (Dark)
TM-T88 II II II II series
Specification
(STANDARD)
OFF
ùReceive buffer full
Fixed to OFF
Fixed to Off
Fixed to Off
Disabled
Disabled
SW 2-3
SW 2-4
ON
ON
OFF
OFF
ON
OFF
OFF
ON
NO.
SHEET
REVISION
NEXT
D
51
SHEET
50
Advertisement
Table of Contents
