Esc C 3 N - Epson TM-T88IIP Manual

Confidential

ESC c 3 n

[Name] Select paper sensor(s) to output paper end signals
[Format] ASCII
Hex
Decimal
0 £ n £ 255
[Range]
[Description] Selects the paper sensor(s) to output paper end signals
· Each bit of n is used as follows:
Bit Off/On Hex
0 Off 00
On 01
1 Off 00
On 02
2 Off 00
On 04
3 Off 00
On 08
4-7 - -
· It is possible to select multiple sensors to output signals. Then, if any of the
[Notes]
sensors detects a paper end, the paper end signal is output.
· The command is available only with a parallel interface and is ignored with a
serial interface.
· Sensor is switched when executing this command. The paper end signal
switching be delayed depending on the receive buffer state.
· If either bit 0 or bit 1 is on, the paper roll near-end sensor is selected as the
paper sensor outputting paper-end signals
· If either bit 2 or bit 3 is on, the paper roll end sensor is selected as the paper
sensor outputting paper-end signals.
· When all the sensors are disabled, the paper end signal always outputs a paper
present status.
[Default] n = 15
TITLE
ESC c
1B 63
27 99
Decimal Function
0 Paper roll near-end sensor disabled
1 Paper roll near-end sensor enabled
0 Paper roll near-end sensor disabled
2 Paper roll near-end sensor enabled
0 Paper roll end sensor disabled
4 Paper roll end sensor enabled
0 Paper roll end sensor disabled
8 Paper roll end sensor enabled
- Undefined
TM-T88 II II II II series
Specification
(STANDARD)
3 n
33 n
51 n
NO.
SHEET
REVISION
NEXT
D
SHEET
99
100