Fs P N M - Epson TM-T88IIP Manual

Confidential

FS p n m

[Name] Print NV bit image
[Format] ASCII
Hex
Decimal
1 £ n £ 255
[Range]
0 £ m £ 3 , 48 £ m £ 51
[Description] Prints a NV bit image n using the mode specified by m .
m Mode
0.48 Normal
1.49 Double-width
2.50 Double-height
3.51 Quadruple
· n is the number of the NV bit image (defined using the FS q command).
· m specifies the bit image mode.
· NV bit image means a bit image which is defined in a non-volatile memory by
[Detail]
FS q and printed by FS p.
· This command is not effective when the specified NV bit image has not been
defined.
· In standard mode, this command is effective only when there is no data in the
print buffer.
· In page mode, this command is not effective.
· This command is not affected by print modes (emphasized, double-strike,
underline, character size, white/black reverse printing, or 90 ° rotated characters,
etc.), except upside-down printing mode.
· If the printing area width set by GS L and GS W for the NV bit image is less than
one vertical line, the following processing is performed only on the line in
question. However, in NV bit image mode, one vertical line means 1 dot in
normal mode ( m = 0, 48) and in double-height mode ( m = 2, 50), and it means 2
dots in double-width mode ( m = 1, 49) and in quadruple mode ( m = 3, 51).
¬ The printing area width is extended to the right in NV bit image mode up to
one line vertically. In this case, printing does not exceed the printable area.
- If the printing area width cannot be extended by one line vertically, the left
margin is reduced to accommodate one line vertically.
· If the downloaded bit-image to be printed exceeds one line, the excess data is
not printed.
· This command feeds dots (for the height n of the NV bit-image) in normal and
double-width modes, and (for the height n ´ 2 of the NV bit-image) in double-
height and quadruple modes, regardless of the line spacing specified by ESC 2
or ESC 3.
· After printing the bit image, this command sets the print position to the beginning
of the line and processes the data that follows as normal data.
[References] ESC * * * * , FS q, GS /, GS v 0
TITLE
FS p
1C 70
28 112
Vertical Dot Density (DPI)
180
180
90
90
TM-T88 II II II II series
Specification
(STANDARD)
n m
n m
n m
Horizontal Dot Density (DPI)
180
90
180
90
NO.
SHEET
REVISION
NEXT
D
SHEET
108
109