Table of Contents
Advertisement
Updating the firmware and the application on a processor module is the same process than
installing a firmware and an application on a very new processor module.
The installation can be performed either via the engineering suite Automation Builder (recom-
mended, for details refer to the software manual) or via memory card
firmware/application update via memory card" on page 108.
Fig. 26: The "Version information" tab of a device in Automation Builder
9.3 Control panel firmware/application update
The system components can be updated via Panel Builder software or via USB flash drive.
Refer to the Panel Builder manual for a detailed description.
9.4 Reset to factory settings
PLC
1.
2.
Control panel
The factory restore of a control panel is described in the Panel Builder manual.
2023/03/03
PLC is in STOP mode.
Press and hold (> 5 sec) [RUN].
ð RUN LED = ON.
"Reset" is displayed.
+
Press [OK] to reset
the PLC.
3ADR011074, 1, en_US
Operation
Reset to factory settings
Ä Chapter 14.2 "PLC
87
Advertisement
Table of Contents
