Table of Contents
Advertisement
Appendix
PLC firmware/application update via memory card > Preparation of memory card
5.
6.
Copy process
1.
with Automation
2.
Builder software
3.
4.
110
Select folder "MEMORY CARD".
ð The "MEMORY CARD" structure has been created and the firmware and application
have been exported.
The created "MEMORY CARD" folder does not contain user data,
remanent data, config data, safety PLC power dip data and safety
PLC password.
Add this data if required by the used application.
Copy all subfolders and files of the "MEMORY CARD" folder to a memory card.
The copy process can be performed with the Automation Builder software with the
memory card inserted in the processor module or with the PC with a suitable memory
card slot.
Insert memory card into the processor module.
Connect the PC to the processor module with an Ethernet cable.
In Automation Builder, log-in to the processor module.
Double-click on the processor module in the device tree and select "Files".
3ADR011074, 1, en_US
2023/03/03
Advertisement
Table of Contents
