Table of Contents
Advertisement
•
Stop and restart a scan.
•
Mode change to another channel, and return to the original channel.
•
Turn off the radio and then turn it on again.
12.5
Changing Priorities Status While Scan is On
While the radio is scanning, the dynamic priority change feature allows you to temporarily change any
channel in a scan list to the Priority-Two channel. You can change any channel except the Priority-One
channel. This change remains in effect until scan is turned off. The scan then reverts to the original
programmed setting.
Procedure:
1 To change the priority of a non-priority channel in the scan list to Priority-Two, press DYNP.
2 To exit the scan list and resume scanning, press the Home button.
12.6
Using the Hang Up Box
Procedure:
1 To temporarily suspend Scan Mode operation, remove the microphone from the Hang Up Box
(HUB).
You are allowed to use the control head while scan is suspended. However, Priority Member
scanning is not suspended. This feature applies to all Scan Lists and Scan Types. Scan is
resumed once the control head is returned to the holding clip and the programmed hangtime has
elapsed.
NOTE: Priority Scan List members are continuously scanned only when the Scan List
Designated Tx Member field is set to Talkback in the radio programming. Otherwise, all
scan mode operation is suspended.
68012006035-FA
Chapter 12 : Scan
71
Advertisement
Table of Contents
