Table of Contents
Advertisement
68012006035-FA
Chapter 9 : Emergency Operation
•
The red LED blinks.
•
The display shows Emergency on the current zone and channel.
The radio exits Emergency Alarm and enters the Emergency Call state when one of the following
scenarios occurs:
•
You receive the dispatcher acknowledgment. The display shows Ack received.
•
You have no acknowledgment. The display shows No acknowledge.
9.7
Exiting Emergency Operation
If an Emergency operation is triggered on your radio, the dispatch console, or radios configured as
Supervisor can exit the Emergency operation. Radios configured as Supervisor can cancel emergency
mode of other radios. The dispatch console must be programmed to use this feature. For more
information, contact your system administrator.
Procedure:
•
To exit the emergency operation, press and hold the programmed Emergency button.
•
To exit the emergency operation as supervisor (Trunking only), use one of the following options:
Option
Exiting Emergency operation initiated by
other radios
Exiting Emergency operation initiated by the
Supervisor
NOTE: Your radio supports the following button combinations:
-
Radio Accessory No-Dot (Purple) button and Emergency button.
-
Radio Accessory No-Dot (Purple) button and accessory Orange button.
-
Accessory 1-Dot button and radio Emergency button.
-
Accessory 1-Dot button and accessory Orange button.
•
To exit the emergency via console (Trunking only), the dispatch operator or supervisor must
clear the emergency.
NOTE: Radios configured as console only cannot cancel emergency mode from the
radio.
•
To exit the emergency operation in Silent Emergency Alarm, press and hold the programmed
Emergency button until a tone sounds.
NOTE: If silent emergency alarm is used with emergency call, press the PTT button to
exit the silent mode.
60
Actions
-
Press and hold the Accessory No-Dot
(Purple) button and press the program-
med Emergency button.
Perform one of the following actions:
-
Press and hold the programmed Emer-
gency button.
-
Press and hold the Accessory No-Dot
(Purple) button, and press the Emer-
gency button.
-
Wait for the console to clear the Emer-
gency.
Advertisement
Table of Contents
