Restoring A Nuisance Channel; Changing Priorities Status While Scan Is On; Restoring Priorities In A Scan List; Using The Hang Up Box (Hub) - Motorola APX Series User Manual

6875947M01-HM
Advanced Features
6.6.4

Restoring a Nuisance Channel

Procedure:
To restore the deleted nuisance channel, perform one of the following actions:
• Stop and restart a scan.
• Mode change to another channel and back to the original channel.
• Turn off the radio and then turn it on again.
6.6.5

Changing Priorities Status While Scan is On

When and where to use:
While the radio is scanning, the dynamic priority change feature allows you to temporarily change any
channel in a scan list (except for the Priority-One channel) to the Priority-Two channel.
This change remains in effect until scan is turned off. Scan then reverts to the preprogrammed
(original) setting.
Procedure:
1 Press the Menu Select button directly below DYNP to change the priority of a non-priority
channel in the scan list to Priority-Two.
2 Press momentarily to exit the scan list and resume scanning.
6.6.6

Restoring Priorities in a Scan List

Procedure:
To restore the original channel priorities in a scan list, perform one of the following actions:
• Turn scan off, and then on.
• Change channels.
• Turn off the radio, and then turn it back on.
6.6.7

Using the Hang Up Box (HUB)

Procedure:
1 To temporarily suspend Scan Mode operation, remove the microphone from the Hang Up Box
(HUB).
You are allowed to use the control head while scan is suspended. However, Priority Member
scanning is not suspended. This feature applies to all Scan Lists and Scan Types. Scan is
resumed once the control head is returned to the holding clip and the preprogrammed hangtime
has elapsed.
NOTICE: Priority Scan List members are continuously scanned only when the Scan List,
Designated Tx Member field is set to "Talkback" in the radio programming. Otherwise,
all scan mode operation is suspended.
54