Table of Contents
Advertisement
2 SAFETY ADVICE
Only operate the vehicle when it is in perfect technical condition, in accordance with its intended use, and in a
safe and environmentally compatible manner.
The vehicle should only be used by trained persons.
Have malfunctions that impair safety immediately eliminated by an authorized Husqvarna Motorcycles work-
shop.
Adhere to the information and warning labels on the vehicle.
2.7
In the interest of your own safety, Husqvarna Motorcycles recommends that you only operate the vehicle while
wearing protective clothing.
2.8
Unless specified otherwise, the ignition must be turned off during all work (models with ignition lock, models
with remote key) or the engine must be at a standstill (models without ignition lock or remote key).
Special tools are necessary for certain tasks. The tools are not a component of the vehicle, but can be ordered
using the number in parentheses. Example: bearing puller (15112017000)
During assembly, use new parts to replace parts which cannot be reused (e.g. self-locking screws and nuts,
seals, sealing rings, O-rings, pins, and lock washers).
In the case of certain screws, a screw adhesive (e.g. Loctite
tions.
If thread locker (e.g., Precote
locker.
After disassembly, clean the parts that are to be reused and check them for damage and wear. Change dam-
aged or worn parts.
After completing a repair or service work, check the operating safety of the vehicle.
2.9
If you use your motorcycle responsibly, you can ensure that problems and conflicts do not occur. To protect
the future of the motorcycle sport, make sure that you use your motorcycle legally, display environmental con-
sciousness, and respect the rights of others.
When disposing of used oil, other operating and auxiliary fluids, and used components, comply with the laws
and regulations of the respective country.
Because motorcycles are not subject to the EU regulations governing the disposal of used vehicles, there are
no legal regulations that pertain to the disposal of an end-of-life motorcycle. Your authorized Husqvarna Motor-
cycles dealer will be glad to advise you.
8
Warning
Danger of burns Some vehicle components become very hot when the vehicle is operated.
–
Do not touch any parts such as the exhaust system, radiator, engine, shock absorber, or brake sys-
tem before the vehicle parts have cooled down.
–
Let the vehicle parts cool down before you perform any work on the vehicle.
Protective clothing
Warning
Risk of injury Missing or poor protective clothing presents an increased safety risk.
–
Wear appropriate protective clothing such as helmet, boots, gloves as well as trousers and a jacket
with protectors on all rides.
–
Always wear protective clothing that is in good condition and meets the legal regulations.
Work rules
®
) has already been applied to a new part, do not apply any additional thread
Environment
®
) is required. Observe the manufacturer's instruc-
Advertisement
Table of Contents
