Table of Contents
Advertisement
8.7.2 Adjusting the Display (DISPLAY menu)
Main menu
Mode
Settings
Service
Information
Language
Continuous
display
8.7.3 HMI logout
Main menu
Mode
Settings
Service
Information
Language
Continuous
display
Service
Clear counters
Display
HMI logout
Security
End
'DISPLAY' sub-menu the LCD screen contrast can be changed
In the
[Arrow keys] .
using the
Service
Clear counters
Display
HMI logout
Security
End
Service
HMI login
End
In this menu you can log into and out of the pump HMI:
To logout run through the menu above. Thereafter the HMI can be
removed from the pump.
Logging on takes place automatically whenever the HMI cable is con‐
nected to the CAN port.
If the HMI must be formally logged into: Logging on via the menu occurs in
exactly the same way as logging off.
If the HMI is disconnected from the CAN bus, without first logging it off, the
pump remains stationary.
WARNING!
An on/off switch may not be fitted on the pump, dependent
on the identity code and installation.
To be able to switch off the pump (to a zero-volts state) inde‐
pendently from the entire installation (e.g. for repair), use an
electrical isolating device in the mains supply cable, e.g. a
mains switch or a plug / socket combination. Clearly identify
this isolating device as such.
Display
Contrast
End
HMI logout
Logout with OK
Back with ESC
Set-up
Contrast
0 4 0 %
HMI logout
HMI successfully
logged out!
61
Advertisement
Table of Contents
