Hmi Operating Unit - ProMinent S1Cb Operating Instructions Manual

Function "External Contact"
(ProMinent external/contact cable)
2-core
Function "External Contact"
(ProMinent universal control wire)
5-core
"Pause" function
"Auxiliary rate" function
Function "External Contact"

7.2.2 HMI operating unit

Universal control wire connection diagram Universal control wire connection diagram
Site end Site end
2 white / Contact
4 brown / GND
Pulse frequency,
e.g. contact water meter, PLC etc.
3 blue / Analog
2 white / Contact
1 brown / Pause
4 black / GND
5 grey /Auxiliary
Pulse frequency,
e.g. contact water meter, PLC etc.
3 blue / Analog
2 white / Contact
1 brown / Pause
4 black / GND
5 grey /Auxiliary
Continuous contact (potential-free)
E.g. external on/off of control panel
3 blue / Analog
2 white / Contact
1 brown / Pause
4 black / GND
5 grey /Auxiliary
Continuous contact (potential-free)
e.g. of control panel
3 blue / Analog
+
2 white / Contact
0/4-20 mA
1 brown / Pause
-
4 black / GND
5 grey /Auxiliary
Analog signal,
e.g. of magnetic inductive
Flow meter
If the pump is operated via the HMI, the HMI must be connected to the
CAN port above the LEDs of the pump base.
Pump, inside Pump, inside
Cable Cable
External
activation
External
activation
External
activation
External
activation
External
activation
P_SI_0091_SW
Installation
GND
GND
GND
GND
GND
41