Upper Limit/ Lower Limit/ Near Zero (Setting Code 06 To 08); (Setting Code 20 To 22); Over/Under Comparison Mode (Setting Code 27) - Unipulse F160 Operation Manual

Setting range and code No. of each set value

■Upper Limit/ Lower Limit/ Near Zero (Setting Code 06 to 08)

These settings are for feed/discharge control, and direct comparisons are made with these values
irrespective of the final value.
Setting range and code No. of each set value
■Over/Under Comparison/ Upper/Lower Limit Comparison/
Near Zero Comparison (Setting Code 20 to 22)
For each comparing point such as final, the comparing weight (gross weight or net weight) and
timing can be selected. The following three items are selectable.
1) Over/under comparison (Code No.20)
Select the weight value for Over/under comparison.
Setting/ 0: Gross weight 1: Net weight 2: Comparison OFF
2) Upper/Lower limit comparison (Code No.21)
Select the weight value for upper/lower limit comparison.
Setting/ 0: Gross weight 1: Net weight 2: Comparison OFF
3) Near zero comparison (Code No.22)
Select the weight value for near zero comparison.
The Near Zero signal turns ON when the comparing weight ≦ near zero set value.
Setting/ 0: Gross weight 1: Net weight 2: Comparison OFF

■Over/Under Comparison Mode (Setting Code 27)

Setting/ 0: Continuous comparison
35
Set value Setting range
Final 00000 to 99999
Set point 1
00000 to 99999
Set point 2
00000 to 99999
CPS
0000 to 9999
Over 000 to 999
Under 000 to 999
Set value Setting range
Upper limit
Lower limit 00000 to 99999
Near zero
3: |Gross weight| 4: |Net weight|
1: Comparison when the external judgment input is ON
2: Comparison when the complete output is ON
3: Comparison, holding the weight value, when the complete output is ON
Initial value Code No.
00000 00
00000 01
00000 02
0000 03
000 04
000 05
Initial value Code No.
06
00000 07
08
5 FUNCTIONS
Chapter
5
35