Zero Calibration (Setting Code 90); Actual Load Calibration (Setting Code 91); Calibration Value Lock (Setting Code 48); Set Value Lock (Setting Code 49) - Unipulse F160 Operation Manual

■Zero Calibration (Setting code 90)

Adjust the initial zero point.
In a set value input state, "0" flashes. Execute with the [
Procedure" on page 13.)
After execution, it goes back to the gross weight display.
When a calibration error is displayed, take measures according to the error message, and do zero
calibration again.
For details of each error, refer to "9-2.Error List" on page 85.

■Actual Load Calibration (Setting code 91)

Calibrates the span with a weight on.
For the setting method, refer to "Example 4) Setting method ② for command execution" on page
15.
When a calibration error is displayed, take measures according to the error message, and do zero
calibration again.
For details of each error, refer to "9-2.Error List" on page 85.

■Calibration Value Lock (Setting code 48)

Upon completion of zero calibration and span calibration, disable changing of calibrated values to
prevent them from being changed carelessly. LOCK is set.
Setting/ 0: Release 1: LOCK
Point

■Set Value Lock (Setting code 49)

Disable changing of set values to prevent them from being changed carelessly. LOCK is set.
Setting/ 0: Release 1: LOCK
Point
21
When the calibration value LOCK is made LOCK, changing of initial setting items
is also disabled. For the setting items the changing of which is disabled, refer to
the "9-1.Setting Code List" on page 78.
For the setting items the changing of which is disabled, refer to the "9-1.Setting
Code List" on page 78.
4 CALIBRATION
] button. (Refer to "3-2.Setting
Chapter
4
21