Table of Contents
Advertisement
7 OPTION (Setting Code 38)
■Setting Item (Setting Code 38)
Chapter
7
■Communication Status Indicators
The communication status is indicated by LED.
54
54
How to connect
Attention
When the DA and DB signal lines and resistance are to be connected to the
connector, be aware that poor contact may result if the nipping conditions differ
between the leg of the resistance and signal lines.
Baud rate [bps]
0: 156k 1: 625k 2: 2.5M
3: 5M 4: 10M
Attention
About setting of Mitsubishi general-purpose PLC CPU unit
If using Mitsubishi general-purpose PLC MELSEC-Q series, please set the
mode configuration and station type as following in the configuration of master
station network parameters.
- Mode configuration:
- Station type:
("Station information" → "Station type")
LED name
LED ON
RUN
- Normal
SD
- Transmitting
RD
- Receiving
- Setting error
ERR
- CRC error
- Fault
- Unsheathe
the
approximately 10mm, insert it in the
upper round hole, and clamp it.
- At this time, operate the lever with
your thumb, while pinching the plug by
hand as shown in the illustration on
the left-hand side.
- Never operate the lever as the plug is
connected; otherwise, the board may
be damaged.
Undefined
Station No.
1 to 63
Remote net Ver.1 mode
Remote device stations
LED OFF
- Reset action
- No communication
- Normal
individual
cable
LED Blinking
Advertisement
Table of Contents
