Error Codes - Elation FUZ035 User Manual

E R R O R C O D E S
When power is applied, the unit will automatically enter a "Motor Reset" mode, which brings
all the internal motors to the home position. If there is an internal problem with one or more
of the motors, an error code (see below) will flash on the control display.
ERROR CODE
TILT Er
PAN Er
DESCRIPTION
The TILT movement is not located in the default position
after the reset. This message will appear after a fixture
reset if the magnetic-indexing circuit malfunctions (sensor
failed or magnet is missing) or there is a motor failure
(defective motor or defective motor IC drive on main PCB).
This error may also occur if the head was blocked during a
reset function
The PAN movement is not located in the default position
after the reset. This message will appear after a fixture
reset if the magnetic-indexing circuit malfunctions (sensor
failed or magnet is missing) or there is a motor failure
(defective motor or a defective motor IC drive on the
main PCB). This error may also occur if the head/yoke was
blocked during a reset function.
28