Table of Contents
Advertisement
S A F E T Y G U I D E L I N E S
• DO NOT TOUCH the fixture housing during operation. Turn OFF the power and allow ap-
proximately 15 minutes for the fixture to cool down before servicing.
• DO NOT shake fixture, and avoid brute force when installing and/or operating fixture.
• DO NOT operate fixture if the power cord is frayed, crimped, damaged, and/or if any of
the power cord connectors are damaged and do not insert into the fixture securely with
ease. NEVER force a power cord connector into the fixture. If the power cord or any of its
connectors are damaged, replace it immediately with a new one of the same power rating.
• DO NOT block any air ventilation slots. All fan and air inlets must remain clean and never
blocked.
• Allow approx. 6" (15cm) between fixture and other devices or a wall for proper cooling.
• When installing fixture in a suspended environment, always use mounting hardware that
is no less than M10 x 25 mm, and always install fixture with an appropriately rated safety
cable.
• Always disconnect fixture from main power source before performing any type of service
and/or cleaning procedure.
• Only handle the power cord by the plug end. Never pull out the plug by tugging the wire
portion of the cord.
• During the initial operation of this fixture, a light smoke or smell may emit from the inte-
rior of the fixture. This is a normal process and is caused by excess paint in the interior of
the casing burning off from the heat associated with the lamp and will decrease gradually
over time.
• Consistent operational breaks will ensure fixture will function properly for many years.
7
Advertisement
Table of Contents
