Table of Contents
Advertisement
E R R O R C O D E S
When power is applied, the unit will automatically enter a "Reset/Test" mode. This mode brings all
the internal motors to a home position. If there is an internal problem with one or more of the motors
an error code will flash in the display in the form of "XXer" were as XX will represent a function number.
For example, when the display shows "0Er" it means there is some type of error with the Pan motor.
If there are multiple errors during the start-up process they will all flash in the display. For example: if
the fixtures has errors on Channel 1, 2, and 5 all at the same time, you will see the error message
"01Er", "02Er", and "05Er" flash repeated 5 times.
If an error does occur during the initial start-up procedure the fixture will self-generate a second reset
signal and try to realign all the motors and correct the errors. If the error persists after a second attempt
a third attempt will be made. If after a third attempt all the errors have not been corrected the fixture
will make the following determinations:
3 or More Errors - The fixture cannot function properly with three or more errors therefore the fixture
will place itself in a stand-by mode until subsequent repairs can be made.
Less Than 3 Errors - The fixture has less than 3 errors; therefore, most other functions will work
properly. The fixture will attempt to operate normally until the errors can be correct by a technician.
The errors in question will remain flashing in the display as a reminder of internal errors.
ERROR CODES
PAN Er
TILT Er
Cyan Color Wheel Er
Magenta Color Wheel Er
Yellow Color Wheel Er
Color Wheel Er
Gobo Wheel 1 Er
Gobo Rotation Wheel 1 Er
Dimmer Wheel Er
Fixed Gobo Wheel Er
Prim 3 Wheel Er
Prism Rotation 1 Wheel Er
Prism 16 Wheel Er
Focus Wheel Er
Zoom Wheel Er
Frost Wheel Er
Error Codes subject to change without notice.
DESCRIPTION
Movement is not located in the default position after the reset.
This message will appear after a fixture reset if the magnetic-indexing circuit
malfunctions (sensor failed, or magnet is missing) or there is a motor failure
(defective motor or a defective motor IC drive on the main PCB). This error
may also be displayed if the head/yoke was blocked during a reset function.
Movement is not located in the default position after the reset.
This message will appear after a fixture reset if the magnetic-
indexing circuit malfunctions (sensor failed, or magnet is
missing) or there is a motor failure (defective motor or a
defective motor IC drive on the main PCB).
52
Advertisement
Table of Contents
