Table of Contents
Advertisement
We recommend to solder the wire rope end thoroughly.
300 kg up to 1500 kg - fastening of the wire rope to the
flanged wheel.
When turning the crank clockwise, the wire rope must
wind up onto the drum anti-clockwise.
Fix the wire rope end to the rope drum by cramming it to
the flanged wheel from outside.
2000 kg and 3000 kg fastening of the wire rope on the
drum
When turning the crank clockwise, the wire rope must
wind up onto the drum also clockwise.
Fix the wire rope end to the rope drum by cramming it.
DANGER!
In case of incorrect winding direction, the load pressure brake is not working.
6.4
Winding up of wire rope
The wire rope must always be winded up tensioned. When the last wire rope layer is winded onto the drum,
the flanged wheel must exceed the top layer by at least 1 1/2 times of the wire rope diameter.
NOTICE!
According to validated regulations and accident prevention regulations, the wire rope length must be
chosen so that at least 2 rope layers remain on the drum when the wire rope is unwinded.
6.5
Wire rope deflection
Wire rope pulleys must be installed in a
position centrically to the rope drum.
In order to ensure correct winding up of the
wire rope on the drum, the max. wire rope
deflection angle must not be exceeded.
maximum wire rope deflection angle
4° for standard wire ropes
2° for non-twisting resp. twist-resistant wire
ropes
The minimum dimension (M) from the drum
until the middle of the pulley must be adhered
to.
7
Control
Only people that are familiar with the operation of the lifting devices and cranes may be entrusted with their
operation. They must be authorized by the employer for the operation of the equipment. The employer must
ensure that the operating instructions are available near the equipment and that they are accessible for the
operating personnel.
5.52.246.00.01.02
Illustration 1
Illustration 2
Illustration 3
9
Advertisement
Table of Contents
