Table of Contents
Advertisement
UC IR & AIRSTREAM APP CONTROL
The UC IR (sold separately) infrared remote gives you control of various functions (See below). To control
the fixture, you must aim the remote at the front of the fixture and be no more than 30 feet away. To use the
ADJ UC IR you must first activate the fixtures infrared sensor, to activate the sensor please see the
instructions on page 20.
The Airstream IR (sold separately) remote transmitter plugs into the headphone jack of your iOS phone or
tablet. To control your IR fixture, you must raise the volume to the maximum on your iOS phone or tablet and
aim the transmitter at the fixture sensor and be no more than 15 feet away. After you have purchased the
Airstream IR transmitters, the app is a free download from the app store for your iOS phone or tablet. The app
comes with 3 pages of control depending on the fixture you are using. Please see below for IR functions
including the corresponding app page.
Works with App page 1.
STAND BY - Pressing this button will blackout the fixture. Press the button again to return to the initial state.
FULL ON - Press this button to fully light up the unit.
FADE/GOBO - This button activates color change mode, color fade mode and color change/fade mode. Each
press of the button will cycle through the modes.
"DIMMER +" and "DIMMER -" - Use these buttons to adjust the output intensity in color mode.
STROBE - Press this button to activate strobing. Use buttons 1-4 to adjust the strobe speed. "1" being the
slowest, "4" being the fastest.
COLOR - Press this button to activate color mode. Use buttons 1-9 to find your desired color.
1-9 - Use buttons 1-9 to select your desired color in static color mode or your desired color fade mode and
color change mode. In color fade mode and color change mode, press the Show 0 button to activate show 10.
Press the 1 button twice to activate show 11.
SOUND ON & OFF - Use the buttons to activate and deactivate sound active mode.
SHOW 0 - See buttons 1-9.
BATTERY STATUS & CHARGING
Battery Status:
This function is used to check the life status of the battery.
Plug the fixture in and press the MODE button until "bXXX" is displayed. "XXX" represents the current battery
life. The number that is displayed is the remaining battery life. If "b---" is displayed, it means that you are
running the unit on AC power. Please do not let the battery fully die, this severely shortens the life of the
battery.
NOTE: When the battery life is below 30% the battery percentage will flash. At 15% power the fixture will shut
off.
NOTE: When using battery power, after 20 seconds of inactivity, the display will revert back to the
battery life display.
Battery Recharge: To recharge the battery, plug the supplied AC cord into the AC input on the side of the unit
and plug the other end into a matching power supply. It takes about 4 hours to reach full charge (with the
power off). The display will STOP flashing when the unit reaches 100% charge.
Note: When unplugging the unit from charging and then applying power via battery, there will be a
minimal charge drop.
For a faster recharge, turn the Load setting to "Off" and turn the battery "On". See LOAD SETTING on page
17.
A.D.J. Supply Europe B.V. – www.adj.eu – Element QAIP Instruction Manual Page 21
Advertisement
Table of Contents
