Map-Select Switch For The Basic Setting; Map-Select Switch For Ride Mode; Launch Control; Overview Of Indicator Lamps - Husqvarna FC 250 2016 Owner's Manual

Hide thumbs Also See for FC 250 2016:
Table of Contents

Advertisement

6
CONTROLS
6.6
Map‑Select switch for the basic setting
6.7
Map‑Select switch for ride mode
6.8

Launch control

The Launch Control assists the rider in optimally starting the motorcycle at the beginning of a race. The maximum speed of the
engine with the throttle valve fully opened (full throttle) is reduced. After the start, it is gradually increased up to the maximum
engine speed. Throughout this procedure, the rider opens the throttle fully and the best possible acceleration is achieved.
The clutch must be activated exactly as it would be without an active Launch Control.
The Launch Control is deactivated in the following cases (FI warning lamp (MIL) no longer flashes):
After full throttle, the throttle valve was closed by more than 1/3 of the way.
There is no start within 3 minutes.
Info
Several seconds after the vehicle starts, Launch Control is deactivated automatically.
6.9

Overview of indicator lamps

The Map‑Select switch for the basic setting
Possible states
1
2
3 - 9, 0
S00922-10
The Map‑Select switch for the basic setting is used to preselect the engine charac-
teristics.
The Map‑Select switch for vehicle operation
dlebar.
Possible states
The engine characteristics can be changed on the handlebar using the
S00923-10
Map‑Select switch for vehicle operation. This change is activated while the engine is
idling or on restarting.
In addition, the Map‑Select switch controls the Launch Control (
Possible states
H00261-10
SOFT – Mapping for softer response is activated. The Launch Con-
trol can be activated.
ADVANCED – Mapping for direct response is activated.
The Launch Control can be activated.
STANDARD – Mapping for balanced response is activated.
The Launch Control cannot be activated.
STANDARD – In this position, STANDARD mapping is always acti-
vated.
SOFT or ADVANCED – In this position, the mapping that is set on
the Map‑Select switch for the basic setting is activated.
FI Warning lamp (MIL) lights up/flashes orange – The OBD has
detected an emission- or safety-critical fault.
FI warning lamp (MIL) flashes fast in orange – The Launch Control
(
p. 12) is activated.
is fitted under the air filter box cover.
is fitted on the right side of the han-
p. 12).
12

Advertisement

Table of Contents
loading

This manual is also suitable for:

F2101p1

Table of Contents