Table of Contents
Advertisement
11
SERVICE WORK ON THE CHASSIS
–
Position the upper triple clamp with the handlebar.
–
Mount screw
H00315-10
–
Position the fork legs.
Bleeder screws
Info
The rebound damping is located in right fork leg REB (red adjusting
screw). The compression damping is located in left fork leg COMP (white
adjusting screw).
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
402556-11
–
Tighten screws
Guideline
Screw, bottom triple clamp
102299-10
–
Tighten screw
Guideline
Screw, top steering head
H00314-10
–
Mount and tighten screw
Guideline
Screw, top steering stem
H00316-10
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
–
Tighten screws
Guideline
Screw, top triple clamp
–
Secure the wiring harness with cable holders
–
Mount the holder with FI warning lamp.
Guideline
Remaining screws, chassis
102299-11
but do not tighten yet.
are positioned toward the front.
.
.
.
M8
.
M8
12 Nm (8.9 lbf ft)
M20x1.5
12 Nm (8.9 lbf ft)
20 Nm
Loctite
(14.8 lbf ft)
M8
17 Nm (12.5 lbf ft)
on the left and right.
M6
10 Nm (7.4 lbf ft)
37
®
243™
Advertisement
Table of Contents
