Display View (diSP)
Use this menu to select the display view.
When the sensor is in sleep mode, the display wakes with the first button press.
—Normal (default setting). When 1234 is inverted, the display is in inverted view model (rotated 180°).
—Normal and the display enters sleep mode after 60 seconds. When oFF is inverted, the display view is inverted (ro
tated 180°) and the display enters sleep mode after 60 seconds.
Units (unIt)
Use this menu to set the displayed units to centimeters (cm), inches ("), millimeters (mm).
•
—centimeter (with a decimal point at < 60 centimeters)
•
—inch (with a decimal point at < 24 inches)
•
— millimeter
Output Type Polarity (PoL)
Use this menu to select the output polarity.
•
(Default)—PushPull IOLink on pin 4 and solid state PNP on pin 2
•
—Solid state PNP on pins 2 and 4
•
—Solid state NPN on pins 2 and 4
Exit Setup Mode (End)
Use this menu to end Setup mode.
Navigate to End and press SELECT to exit Setup mode and return to Run mode.
Reset to Factory Defaults
Use this menu to restore the sensor to the factory default settings.
—Select to return to the sensor menu without restoring the defaults.
—Select to apply the factory defaults and return to Run mode.
Factory Default Settings for the Q5X Dual Discrete with IO-Link
The 2000 mm model and the 5000 mm model have different factory default settings.
Factory Default Settings
Delay Timers (
Display View (
Gain and Sensitivity (
Output (
Response Speed (
Shift the Zero Reference Location after
a TEACH (
TEACH Mode (
Zero Reference Location (
July 25, 2023
Setting
)
)
)
,
)
)
)
)
)
from sensor
Q5X With Dual Discrete Outputs And IO-Link Instruction Manual
2000 mm Model Factory Default
—No delay
—Normal, no sleep mode
—High excess gain mode
—Light Operate
—25 ms
—0 = the front of the sensor
—Twopoint TEACH
—Measurement increases further
Continued on page 26
© Banner Engineering Corp.
5000 mm Model Factory Default
—No delay
—Normal, no sleep mode
PErF
—Light Operate
—50 ms
—0 = the front of the sensor
—Twopoint TEACH
—Measurement increases
further from sensor
25