Table of Contents
Advertisement
Troubleshooting
1. Run the USB2ANY Firmware Loader program. The installation program will normally create an icon for
it on your desktop. By default, the program will be located in the bin folder of the TI USB2ANY SDK
folder (for example, C:\Program Files (x86)\TI USB2ANY SDK\bin).
The program dialog will look like this:
2. Near the top of the dialog, you should see a list of available devices (there is usually only one device),
with the first device highlighted.
3. If more than one device is displayed, select the desired device using the mouse or arrow keys. If you
connect, re-connect, or change devices while the program is running, click the Refresh List button to
update the displayed list.
4. By default, the program will show the recommended firmware version in the Update to firmware
version drop-down list box. If you want to load an older version of firmware, click the down-arrow
button to the right of the list box to display a list of other available versions.
5. Click the Update Firmware button.
6. A confirmation dialog box will display the firmware version selected for the update and prompt to verify
that you want to proceed. Click the Yes button to continue.
7. A new dialog will appear. If the first line of text says The USB2ANY is ready for download, proceed to
step 9 (that is, skip step 8).
8. The dialog will display instructions for preparing the USB2ANY for the firmware download. Follow the
instructions, referring to
connector. If the USB2ANY is in an enclosure, you will need to insert an implement (a paper clip works
great) into the small hole to press the button.
26
DS90UB95x-Q1 Serializer Evaluation Module
Figure 31. USB2ANY Firmware Loader Program Dialog
Figure 32
and
Figure 33
Copyright © 2017–2019, Texas Instruments Incorporated
for locations of the BSL button (S1 switch) and USB
SNLU224A – September 2017 – Revised May 2019
www.ti.com
Submit Documentation Feedback
Advertisement
Table of Contents
