Table of Contents
Advertisement
CLEANING & CARE
To ensure optimal performance, it is recommended to clean your ice maker at least once a
week.
1.
Stop the ice-making cycle by pressing the "ON/OFF" key, unplug the ice maker
from the wall outlet and allow it to warm up to room temperature.
2.
If residual water is found in the ice tray, gently push the ice tray back so that all
water drains into the water reservoir.
3.
Move the ice maker so that it is over hangs approximately 60mm from the edge of
the working table and open the drain plug to drain out excess water (refer Fig.1,
Fig.2 and Fig.3).
4.
Replace the drain plug and ensure it is closed well. Fill the water reservoir with
clean water, press "SELECT" until the "
"ON/OFF" key, the pump will start to pump water and keep running for 6 minutes
and then will enter standby. Open the drain plug and empty the water.
5.
Remove the ice basket.
6.
Clean the ice maker interior with a soft cloth soaked with warm water and vinegar,
then rinse with clean water and then drain all the water.
7.
Replace the drain plug and ensure it is closed well. Wash the ice basket and ice
scoop in warm soapy water. Rinse and dry.
8.
Clean the exterior of the ice maker with a soft damp cloth. Use a mild dishwashing
soap, if necessary.
Note:
Do not use solvents, boiling water, detergent, strong acid and strong alkali etc. for
cleaning.
9.
Please empty the water reservoir and dry it for storage if the ice maker is not used
for a long time.
" indicator flashes, then press the
Advertisement
Table of Contents
